Management Networks Configuration; User Access Control Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

Table 94 System Access Configuration Menu options
Command
tport <TFTP port number> Sets an optional telnet server port number for cases where the server listens for
cur

Management Networks configuration

Command: /cfg/sys/access/mgmt
[Management Networks Menu]
The following table describes the Management Networks Configuration menu options. You can configure
up to 10 management networks on the switch.
Table 95 Management Network Configuration menu options
Command
add <IP address> <IP mask>
rem <IP address> <IP mask>
cur
clear

User Access Control configuration

Command: /cfg/sys/access/user
[User Access Control Menu]
Description
TFTP sessions on a non-standard port.
Displays the current system access parameters.
add - Add mgmt network definition
rem - Remove mgmt network definition
cur - Display current mgmt network definitions
clear - Clear current mgmt network definitions
Description
Adds a defined network through which switch access is allowed through
Telnet, SNMP, RIP, or the browser-based interface. A range of IP addresses is
produced when used with a network mask address. Specify an IP address
and mask address in dotted-decimal notation.
Removes a defined network, which consists of a management network
address and a management network mask address.
Displays the current management networks parameters.
Clears the management network definitions.
uid - User ID Menu
eject - Eject user
usrpw - Set user password (user)
opw - Set operator password (oper)
admpw - Set administrator password (admin)
cur - Display current user status
Configuration Menu
123