Route Map Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Route Map configuration

Routing maps control and modify routing information. The map number <1-32> represents the routing
map you wish to configure.
The following table describes the basic Route Map Configuration commands. The following sections
provide more detailed information and commands.
Route Map Configuration commands
Table 126
Command
route-map <1-32>
[no] access-list <1-8>
[no] metric <0-16777214>
[no] metric-type {type1|type2}
precedence <1-256>
enable
no enable
no route-map <1-32>
show route-map [<1-32>]
Description
Enter Route Map configuration mode.
Command mode: Global configuration
Configures the Access List.
Command mode: Route Map
Sets the metric of the matched route.
Command mode: Route Map
Assigns the type of OSPF metric. The default is type 1.
Type 1—External routes are calculated using both internal and
external metrics.
Type 2—External routes are calculated using only the external
metrics. Type 2 routes have more cost than Type 2.
none—Removes the OSPF metric.
Command mode: Route Map
Sets the precedence of the route map. The smaller the value, the
higher the precedence. Default value is 10.
Command mode: Route Map
Enables the route map.
Command mode: Route Map
Disables the route map.
Command mode: Route Map
Deletes the route map.
Command mode: Route Map
Displays the current route configuration.
Command mode: All except User EXEC
Configuration Commands
147