Diffserv Wizard - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

DiffServ Wizard

The DiffServ Wizard enables DiffServ on the switch by creating a traffic class, adding the
traffic class to a policy, and then adding the policy to the ports selected on DiffServ Wizard
page. The DiffServ Wizard will:
• Create a DiffServ Class and define match criteria used as a filter to determine if incoming
traffic meets the requirements to be a member of the class.
• Set the DiffServ Class match criteria based on Traffic Type selection as below:
• VOIP - sets match criteria to UDP protocol.
• HTTP - sets match criteria to HTTP destination port.
• FTP - sets match criteria to FTP destination port.
• Telnet - sets match criteria to Telnet destination port.
• Every - sets match criteria all traffic.
• Create a Diffserv Policy and add it to the DiffServ Class created.
• If Policing is set to YES, then DiffServ Policy style is set to Simple. Traffic which
conforms to the
Priority selection. Outbound Priority configures the handling of conforming traffic as
below:
• High - sets policing action to markdscp ef.
• Med - sets policing action to markdscp af31.
• Low - sets policing action to send.
• If Policing is set to NO, then all traffic will be marked as specified below:
• High - sets policy mark ipdscp ef.
• Med - sets policy mark ipdscp af31.
• Low - sets policy mark ipdscp be.
• Each port selected will be added to the policy created.
Class Match criteria will be processed according to the Outbound
Chapter 5. Configuring Quality of Service | 409