NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual page 452

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
To access the HTTP Configuration page, click Security > Access> HTTP
Configuration.
To configure the HTTP server settings:
1. Use HTTP Access to specify whether the switch may be accessed from a web browser.
If you choose to enable web mode you will be able to manage the switch from a web
browser. The factory default is enabled.
2. Use Java Mode to enable or disable the java applet that displays a picture of the switch at
the top right of the screen. If you run the applet you will be able to click on the picture of the
switch to select configuration screens instead of using the navigation tree at the left side of
the screen. The factory default is disabled.
3. Use HTTP Session Soft Timeout(Minutes) to set the inactivity time-out for HTTP sessions.
The value must be in the range of (1 to 60) minutes. The default value is 5 minutes. The
currently configured value is shown when the web page is displayed.
4. Use HTTP Session Hard Timeout(Hours) to set the hard time-out for HTTP sessions. This
time-out is unaffected by the activity level of the session. The value must be in the range of
(1 to 168) hours. The default value is 24 hours. The currently configured value is shown
when the web page is displayed.
5. Use Maximum Number of HTTP Sessions to set the maximum allowable number of HTTP
sessions. The value must be in the range of (0 to 16). The default value is 16. The currently
configured value is shown when the web page is displayed.
Table 6-86.
Field
Authentication List
452 | Chapter 6. Managing Device Security
Description
Shows the authentication list which HTTP are using.

HTTP