Advanced - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

Advanced

.From the Advanced link, you can access the following pages:
• Static ARP Cache
• ARP Table Configuration
Static ARP Cache
To display the Static ARP Cache page, click Routing
ARP Static Configuration
Use this screen to add an entry to the Address Resolution Protocol table.
1. Use IP Address to enter the IP address you want to add. It must be the IP address of a
device on a subnet attached to one of the switch's existing routing interfaces.
2. Use MAC Address to specify the unicast MAC address of the device. Enter the address as
six two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
3. Click ADD to add a new static ARP entry to the switch.
4. Click DELETE to delete an existing static ARP entry from the switch.
5. Click APPLY to change the MAC Address mapping to the IP. Configuration changes take
effect immediately.
on page 255
on page 257
  
ARP Advanced ARP Create.
Chapter 4. Routing | 255