NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual page 299

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
OSPFv3 Configuration
Use the OSPFv3 Configuration page to activate and configure OSPFv3 for a switch.
To display the OSPFv3 Configuration page, click Routing
Configuration.
Default Route Advertise
1. Use Default Information Originate to enable or disable Default Route Advertise. Note
that the values for 'Always', 'Metric' and 'Metric Type' can only be configured after
Default Information Originate is set to enable. If Default Information Originate is set to
enable and values for 'Always', 'Metric' and 'Metric Type' are already configured, then
setting Default Information Originate back to disable will set the 'Always', 'Metric' and
'Metric Type' values to default.
2. Use Always to set the router advertise when set to "True".
3. Use Metric to specify the metric of the default route. The valid values are 0 to 16777214.
4. Use Metric Type to set the metric type of the default route. Valid values are External Type
1 and External Type 2.
 
OSPFv3 Advanced
Chapter 4. Routing

OSPFv3
| 299