ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Advanced
From the Advanced link, you can access the following pages:
•
Global Configuration
•
Interface Configuration
•
ISDP Neighbor
•
ISDP Statistics
Global Configuration
To display this page, click System
similar to the following displays.
1.
Use Admin Mode to specify whether the ISDP Service is to be Enabled or Disabled.
The default value is Enabled.
2.
Use Timer to specify the period of time between sending new ISDP packets. The range is 5
to 254 seconds. Default value is 30 seconds.
3.
Use Hold Time to specify the hold time for ISDP packets that the switch transmits. The hold
time specifies how long a receiving device should store information sent in the ISDP packet
before discarding it. The range 10 to 255 seconds. Default value is 180 seconds.
4.
Use Version 2 Advertisements to enable or disable the sending of ISDP version 2 packets
from the device. The default value is Enabled.
124 |
Chapter 2. Configuring System Information
on page 124
on page 126
on page 127
on page 128
ISDP
Advanced
Global Configuration. A screen