NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual page 264

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
RIP Status
Table 26.
Field
Interface
IP Address
Send Version
Receive Version
Admin Mode
Link State
Bad Packets Received
Bad Routes Received
Updates Sent
Click REFRESH to show the latest RIP information.
264 | Chapter 4. Routing
Description
Displays the interface for which data is configured.
Displays the IP Address of the router interface.
Displays the version of RIP control packets the
interface should send from the pull-down menu. The
value is one of the following:
•
RIP-1 - send RIP version 1 formatted packets via
broadcast.
• RIP-1c - RIP version 1 compatibility mode. Send
RIP version 2 formatted packets via broadcast.
•
RIP-2 - send RIP version 2 packets using
multicast. The default is RIP-2.
• None: no RIP control packets will be sent.
Displays what RIP control packets the interface will
accept from the pull-down menu. The value is one of
the following:
•
RIP-1 - accept only RIP version 1 formatted
packets.
•
RIP-2 - accept only RIP version 2 formatted
packets. The default is RIP-2.
•
Both - accept packets in either format.
•
None - no RIP control packets will be accepted.
Enables RIP for an interface. The default is Disable.
Indicates whether the RIP interface is up or down.
The number of RIP response packets received by
the RIP process which were subsequently discarded
for any reason.
The number of routes, in valid RIP packets, which
were ignored for any reason (e.g., unknown address
family, or invalid metric).
The number of triggered RIP updates actually sent
on this interface. This explicitly does NOT include full
updates sent containing new information.