ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
MLD VLAN Configuration
To access the MLD VLAN Configuration page, click Switching
MLD VLAN Configuration.
1.
Use VLAN ID to set the VLAN IDs for which MLD Snooping is enabled.
2.
Use Admin Mode to enable MLD Snooping for the specified VLAN ID.
3.
Use Fast Leave Admin Mode to enable or disable the MLD Snooping Fast Leave Mode for
the specified VLAN ID.
4.
Use Group Membership Interval to set the value for group membership interval of MLD
Snooping for the specified VLAN ID. Valid range is (Maximum Response Time + 1) to 3600.
5.
Use Maximum Response Time to set the value for maximum response time of MLD
Snooping for the specified VLAN ID. Valid range is 1 to (Group Membership Interval - 1).Its
value should be less than group membership interval value.
6.
Use Multicast Router Expiry Time to set the value for multicast router expiry time of MLD
Snooping for the specified VLAN ID. Valid range is 0 to 3600.
Multicast
Chapter 3. Configuring Switching Information
MLD Snooping
| 187