NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual page 309

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Interface Configuration
Use the OSPFv3 Interface Configuration page to create and configure OSPFv3 interfaces.
To display the Interface Configuration page, click Routing
Configuration.
1. Interface - The interface for which data is to be displayed or configured.
2. Use Area ID to enter the 32-bit integer in dotted decimal format that uniquely identifies the
OSPFv3 area to which the selected router interface connects. If you assign an Area ID
which does not exist, the area will be created with default values.
3. Use Admin Mode* to select enable or disable. The default value is 'disable.' You can
configure OSPFv3 parameters without enabling OSPFv3 Admin Mode, but they will have no
effect until you enable Admin Mode. The following information will be displayed only if the
Admin Mode is enabled: State, Designated Router, Backup Designated Router, Number of
 
OSPFv3 Advanced
Chapter 4. Routing

Interface
| 309