Auto Install Configuration; Reset; Device Reboot - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual

Auto Install Configuration

To access the Auto Install Configuration page, click Maintenance
Configuration.
1. Use Auto Install to enable/disable start/stop auto install mode on the switch.
2. Select the Auto Save check box and click the APPLY button to have configuration changes
you have made saved across a system reboot. All changes submitted since the previous
save or system reboot will be retained by the switch.
3. Use Auto Install Retry Count to specify the number of times the unicast TFTP tries should
be made for the DHCP specified file before falling back for broadcast TFTP tries.

Reset

The Reset menu contains links to the following options:
•

Device Reboot

• Factory Default
• Password Reset
Device Reboot
Use the Device Reboot page to reboot ProSafe® Managed Switches.
To access the Device Reboot page, click Maintenance
580 | Chapter 8. Maintenance
on page 580
on page 582
on page 583

Save Config
 
Reset Device Reboot.

Auto Install