NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch User Manual page 145

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
1. Use Group Name to assign a name to a new group. You may enter up to 16 characters.
2. Use Protocol(s) to select the protocols you want to be associated with the group. There are
three configurable protocols: IP, IPX, ARP.
• IP - IP is a network layer protocol that provides a connectionless service for the
delivery of data.
• ARP - Address Resolution Protocol (ARP) is a low-level protocol that dynamically
maps network layer addresses to physical medium access control (MAC) addresses
• IPX - The Internetwork Packet Exchange (IPX) is a connectionless datagram
Network-layer protocol that forwards data over a network.
3. Use VLAN ID to select the VLAN ID. It can be any number in the range of 1 to 4093. All the
ports in the group will assign this VLAN ID to untagged packets received for the protocols
you included in this group.
4. Click ADD to add a new Protocol Based VLAN group to the switch.
5. Click DELETE to remove the Protocol Based VLAN group identified by the value in the
Group ID field.
Table 3-50.
Field
Group ID
Ports
Description
A number used to identify the group created by the
user. Group IDs are automatically assigned when a
group is created by the user.
Display all the member ports which belong to the
group.
Chapter 3. Configuring Switching Information | 145