Configuring Zone Sets - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring Zones
• Add member by domain ID and port number — Type the domain ID
(1 through 31) of the switch in the Domain ID field, type the switch port
number to which a device is attached, and click the adjacent Add Member
button. The device attached to that port is added to the zone.
• Delete a member — To delete a zone member, click the Delete button
adjacent to the configured zone member (WWN or domain ID and port
number) at the bottom of the page. A confirmation dialog box displays. Click
OK to delete the zone member.
7. Changes to a zone, zoning configuration, or zone member are not saved and
activated on the switch until saved as part of a zone set. Go to
Sets below to perform this function.
8. Up to 64 zones may be displayed on a single page. If a zone set has more than 64
zones defined, you can display additional pages by choosing Display Previous
Zones or Display More Zones. These fields are grayed out if there are 64 or
fewer zones defined for a zone set.

Configuring Zone Sets

Perform this procedure to configure, change, enable, or disable zone sets. A zone set is
a group of zones that is activated or deactivated as a single entity across all managed
products in either a single switch or a multiswitch fabric. Only one zone set can be
active at one time. To configure zone sets:
1. Choose Configure from the navigation panel.
2. Choose the Zoning tab and the Zone Set tab. The Zone Set tab view displays
(Figure 3–5 on page
3–14
3-15).
Configuring Zone
embedded web server user guide