Set Individual Port Beaconing On Or Off - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

If the product configuration is reset, management access of the product may be lost
until the network information is restored. The product must be offline before the
configuration can be reset. See
NOTE: Since the current IP address for the product may not match the factory default values,
the Ethernet link between the product and the service processor may drop and not reset. Make
sure you record the product's current IP address as you will want to enter that value in the IP
Address, under the Configure page, Switch or Director tab as appropriate, and Network tab.
See Configuring Network Information on page 2-12
NOTE: After you reset the product configuration, you should view the product information page
as described in
to a file or print the page to verify the changes you made and to identify the default values.

Set Individual Port Beaconing On or Off

Choose Operations from the navigation panel. Choose the Port tab and the Beacon
tab; the Beacon tab view displays
disable beaconing for individual ports. Enabling beaconing helps you to locate a
specific port for troubleshooting purposes by the use of flashing port LED. When
there are multiple products stacked together, such as in a rack-mount cabinet,
beaconing is useful to help locate a specific port by turning beaconing on for only that
port.
The first column shows the port number, the second column contains the port name, as
configured in the Ports tab view on the Configure page, and the third column contains
check boxes to enable/disable beaconing.
A checked box indicates beaconing is active, an empty box indicates beaconing is not
active for the port. To change the state click once inside the box. When finished, click
Activate to enable the new configuration, or Cancel to return to previous
configuration. If your changes are successful, a message displays stating that your
changes to the configuration have been successfully activated.
NOTE: For the Director 2/140, the ports are displayed through several pages in groups of 32.
To configure the port beaconing, make sure you go through each set of ports.
embedded web server user guide
Installing Feature Keys on page 2-22
Obtaining Product Information on page
(Figure 6–4 on page
Operating and Managing Products and Parts
for instructions.
6-13. Save the product information page
6-6). Use this view enable or
for instructions.
6–5