Factory Default Values; Configuring Ports - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring the Product

Factory Default Values

HP products on a SAN have preset, default configuration values that were set in the
factory. The items that have factory-set default values are:
• Passwords (customer and maintenance-level)
• Internet Protocol (IP) address
• Subnet mask
• Gateway address
The specific default values associated with a particular HP product are documented in
the installation and service manual for the product.

Configuring Ports

Perform procedures in this section to configure names and operating characteristics
for Fibre Channel ports. To configure one or more ports:
1. If you are going to change the Speed parameter on an Director 2/64, set the
product offline as follows:
a. Choose Operations from the navigation panel. The Operations page
displays.
b. Click the Online State tab, then click Set Offline. The message Your
operations changes have been successfully activated
displays.
2. At the EWS screen, choose Configure from the navigation panel. The Configure
page and the Ports tab view display
NOTE: Because the Director 2/140 has many ports, the listing of ports is divided into separate
displays, which are accessed by clicking the hyperlinks 1-31, 32-63, 64-95, 96-127, and
132-143. If you make any changes to a particular list of ports, click Activate before selecting
another list of ports. If you do not click Activate, changes are not implemented on the Director.
2–2
(Figure 2–1 on page
embedded web server user guide
2-3).