Configuring the Product
Configuring Operating Parameters
Perform this procedure to configure the product's preferred domain ID, insistent
domain ID, rerouting delay, and domain registered state change notifications
(RSCNs). The product must be set offline to configure the preferred domain ID. To
configure parameters:
1. Set the product offline as follows:
a. Choose Operations from the navigation panel. The Operations page
displays.
b. Click the Online State tab, then click Set Offline. The message Your
operations changes have been successfully activated
displays.
2. Choose Configure from the navigation panel. The Configure page displays.
3. Click the Switch or Director tab, as appropriate. Click the Parameters tab to
display the Parameters tab view
Figure 2–4: Configure product parameters tab view
a. At the Preferred Domain ID field, type a value of 1 through 31. The domain
ID uniquely identifies each product in a fabric.
NOTE: If the product is attached to a fabric element, the product and element must have unique
domain IDs. If the values are not unique, the E_Port connection to the element cannot carry
traffic and the product cannot communicate with the fabric.
2–8
(Figure
2–4).
embedded web server user guide