Where To Start; Starting Ews - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Where to Start

Depending upon whether the Hewlett-Packard product you purchased has already
been installed, you may need to go to a specific chapter. If the product has not been
installed, you should start at
If the product was installed, then many of the configuration tasks were probably
already completed. In that case, you may need to configure a zone. Configuring
(including adding, deleting, and changing) zones is described in
Configuring
If the products have been configured and you have a functioning SAN, then you most
likely will be interested in performing system administration tasks. Those tasks are
described in
Products; and
If you need to perform troubleshooting, then you will want to review
Monitoring Products, and

Starting EWS

Open the EWS interface as follows:
1. Ensure the workstation (or device you use to launch the web browser) and the
Ethernet LAN segment containing the product, such as Edge Switch 2/24, are
attached and connected through the Internet.
You must be able to make a connection between the web browser and the
NOTE:
product in order to login to the product.
2. Launch the web browser application (such as Netscape Navigator, version 4.6 or
higher, or Microsoft Internet Explorer, version 4.0 or higher).
3. At the web browser, enter the IP address of the product as the Internet uniform
resource locator (URL) such as http://10.1.1.11.
NOTE: If the product has not been installed, refer to the product's installation and service
manual for the appropriate IP address, login ID, and password that is initially used when you
install and configure the product.
embedded web server user guide
Chapter 2, Configuring the
Zones.
Chapter 4, Viewing Product and Fabric
Chapter 6, Operating and Managing Products and
Chapter 6, Operating and Managing Products and
Product.
Chapter 3,
Data; Chapter 5, Monitoring
Parts.
Chapter 5,
Introduction
Parts.
1–7