Configure Zone Sets; Zoning Page-Zone Set Tab - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

— Delete a member - To delete a zone member, click the Delete button adjacent
to the configured zone member (WWN or domain ID and port number) at the
bottom of the page. A confirmation dialog box displays. Click OK to delete
the zone member.
Changes to a zone, zoning configuration, or zone member are not saved and activated
on the switch until saved as part of a zone set. Go to
page 2–25 to perform this function.

Configure Zone Sets

Perform this procedure to configure, change, enable, or disable zone sets. A zone set is
a group of zones that is activated or deactivated as a single entity across all managed
products in either a single switch or a multi-switch fabric. Only one zone set can be
active at one time. To configure zone sets:
1. At the Configure panel and Zoning page, click the Zone Set tab. The Zoning
page displays with the Zone Set tab selected, as shown in
Figure 2–15: Zoning page—Zone Set tab
2. To create a zone set that incorporates zones and zone members (configured under
"Configure
Name field.
edge switch 2/24 installation guide
Zones" on page 2–22), type a new zone set name in the Zone Set
Installing and Configuring the Edge Switch 2/24
"Configure Zone
Figure
Sets" on
2–15.
2-25