Configuring Zones; Configuring Zone Sets - HP FlexFabric 5700 Series Configuration Manual

Step
3. Create a zone alias and
enter its view.
4. Add a member to the zone
alias.

Configuring zones

You can configure a maximum of 4000 zones for all VSANs on a switch.
You can specify members of a zone by using their FC addresses, pWWNs, fWWNs, or zone aliases. An
fWWN is the WWN of an F_Port. An F_Port member represents all N_Ports that log in through the F_Port.
A zone alias represents a group of N_Ports. Any specified N_Port members can be indirectly connected
to the switch. A member can belong to more than one zone.
You can specify the role of a member as an initiator, a target, or both when adding the member. The role
can be configured only in enhanced zoning mode and takes effect only when the Pairwise feature is
enabled.
To configure a zone:
Step
1. Enter system view.
2. Enter VSAN view.
3. Create a zone and enter
its view.
4. Add a member to the
zone.

Configuring zone sets

You can configure a maximum of 128 zone sets for all VSANs on a switch.
To configure a zone set:
Step
1. Enter system view.
2. Enter VSAN view.
3. Create a zone set and
enter its view.
4. Add a zone to the zone
set.
Command
zone-alias name zone-alias-name
member { fcid fcid | fwwn fwwn |
pwwn pwwn } [ initiator | target ]
Command
system-view
vsan vsan-id
zone name zone-name
member { { fcid fcid | fwwn fwwn |
pwwn pwwn } [ initiator | target ] |
zone-alias zone-alias-name }
Command
system-view
vsan vsan-id
zoneset name zoneset-name
member zone-name
82
Remarks
If the zone alias has been created,
enter its view directly.
By default, no member exists in a
new zone alias.
Remarks
N/A
N/A
If the zone has been created, enter
its view directly.
By default, no member exists in a
new zone.
Remarks
N/A
N/A
If the zone set already exists, you
directly enter its view.
By default, no zone exists in a new
zone set.