Table 11 Failure Events Detail - Tandberg Data MSERIES RMC USER User Manual

Tape Alert E-mail Message Error
Flag Type
1 Soft Error
2 Soft Error
3 Hardware Failure
7 Soft Error
8 Soft Error
15 Soft Error
16 Soft Error
18 Soft Error
21 Soft Error
23 Soft Error
29 Soft Error
32 Hardware Failure
34 Soft Error
35 Soft Error
36 Soft Error
37 Soft Error
38 Soft Error
39 Soft Error
42 Hardware Failure
46 Soft Error
65 Soft Error
69 Soft Error
Table 11 Failure
Events Detail
E-mail Message Error
FSC Code Type
0001 Hardware Failure
0002 Hardware Failure
0003 Hardware Failure
0004 Soft Error
Tandberg Data M-Series Remote Management Card User's Guide
Description
The drive is having severe trouble reading the media
The drive is having severe trouble writing to the media
The drive had a hard read or write error
The media has exceeded its specified life
The drive has not been able to read the MRS stripes
Memory chip failed in cartridge
Manual or forced eject while drive actively writing or reading
Directory data stored on tape has been corrupted
The drive is ready for a periodic cleaning
Invalid cleaning tape type used
The drive requires preventive maintenance other than cleaning
The drive has identified an interfacing fault
Firmware download failed
Drive humidity limits exceeded
Drive temperature limits exceeded
Drive voltage limits exceeded
Predictive failure of drive hardware
The drive may have a hardware fault that extended diagnostics may
help identify
Library mechanism has a hardware fault
Predictive failure of loader mechanism hardware
Unknown tape alert flag
Unknown tape alert flag
Description
A divide by zero exception has occurred
A parity error has been detected on the address/data bus
Out of memory
_flsbuf was called
63