Tandberg Data MSERIES RMC USER User Manual page 17

If DHCP is not available on your network for IP addressing,
the DHCP request times out after approximately 30 seconds.
The RMC then assigns itself the static IP address of
If 198.168.x.x is already used in the network, 10.0.0.x will be
used instead.
In the
Address
This static IP address is the default address for accessing the
RMC.
The
Subnet Mask
is different, you need to set up an isolated network, access the
RMC, and modify it from the Management Console Web pages
and add it into the appropriate network.
In some cases, you may have to temporarily
Note:
configure a host computer's network configuration to
the IP address 192.168.1.x, where x is some number
between 2 and 254. Enter the subnet mask as
255.255.255.0
Using your browser, enter
Management Console Web page. At this point,
change the RMC network configuration to an
appropriate IP address and subnet mask for your
network.
If you are still having problems accessing the IP address,
contact your local system administrator for information on
including the RMC in your network.
The Internet browser displays the Management Console
page as shown in
Tandberg Data M-Series Remote Management Card User's Guide
Chapter 1 RMC Server Management
field of your browser, type
default is
255.255.255.0
.
figure 1.
Management Console Web Pages
192.168.1.1
http://192.168.1.1/
. If your subnet mask
to access the
192.168.1.1
.
.
Home
3