Table 10 Warning Events Detail - Tandberg Data MSERIES RMC USER User Manual

Tape Alert E-mail Message Error
Flag Type
10 Soft Error
11 Soft Error
12 Soft Error
17 Soft Error
19 Soft Error
Table 10 Warning
Events Detail
E-mail Message Error
FSC Code Type
000A Hardware Failure
000B Hardware Failure
000C Hardware Failure
000D Hardware Failure
000E Hardware Failure
000F Hardware Failure
0020 Soft Error
200A Hardware Failure
200B Hardware Failure
200C Hardware Failure
200D Hardware Failure
200E Hardware Failure
200F Hardware Failure
2022 Hardware Failure
202C Hardware Failure
202D Hardware Failure
202E Hardware Failure
202F Hardware Failure
60 Tandberg Data M-Series Remote Management Card User's Guide
Description
Manual or software unload attempted while prevent media
removal on
Cleaning tape encountered during backup or restore
Attempted load of unsupported tape format
Media loaded that is read-only format
The tape cartridge is nearing the end of its calculated life
Description
Hand CV check found hand disconnected
Servo CV check found servo board disconnected
X axis CV check found X axis disconnected
Y axis CV check found Y axis disconnected
Z axis CV check found Z axis disconnected
FP CV check found front panel disconnected
OS timer interrupt has not occurred, but should have
Drive caddy not present (drive 1 in this frame)
Drive caddy not present (drive 2 in this frame)
Drive caddy not present (drive 3 in this frame)
Drive caddy not present (drive 4 in this frame)
Drive caddy not present (drive 5 in this frame)
Drive caddy not present (drive 6 in this frame)
The requested function is not implemented in the drive type
Response packet received from drive 1 in this frame indicates
command failed
Response packet received from drive 2 in this frame indicates
command failed
Response packet received from drive 3 in this frame indicates
command failed
Response packet received from drive 4 in this frame indicates
command failed