Initializing Statistics; Library Firmware Upload - Tandberg Data MSERIES RMC USER User Manual

Chapter 4 ALERT Library Management
Service Operations
Initializing
4
Statistics
Library Firmware
4
Upload
46 Tandberg Data M-Series Remote Management Card User's Guide
• Check Y-Axis Sensor
• Check Picker-Axis Sensor
• Check Theta-Axis Sensor 1
• Check Theta-Axis Sensor 2
• Check Elevator-Axis Sensor
Press . A
2 Apply Results
Press to return to the
3 OK
To initialize the statistics functions of the library:
In the section of the page, select
1 Selftest
Initializing
Caution:
statistics listing with the exception of the
Hours
Press . A
2 Apply Results
is complete.
Press to return to the
3 OK
To upload the library firmware:
Press to select the appropriate image file on the host
1 Browse
computer.
Press to begin the library firmware upload.
2 Upload
Before you perform the upload, make sure there
Caution:
are no processes or applications accessing the
library. If there are, shut down the process or
application, or pause the operation, until the
upload completes.
Make sure the image file is valid otherwise you
may render the library unusable after the upload.
page indicates the self-test is complete.
Service Operations
resets all values in the
Statistics
.
page indicates the initialization, or reset,
Service Operations
page.
.
Statistics
Power On
page.