Tandberg Data MSERIES RMC USER User Manual page 69

E-mail Message Error
FSC Code Type
401B Operator Access
401C Operator Access
401D Operator Access
401E Operator Access
401F Operator Access
4020 Operator Access
4100 Configuration Change
4101 Configuration Change
4102 Configuration Change
4103 No mail generated
4104 Configuration Change
4105 No mail generated
4106 Soft Error
4107 Soft Error
4108 Soft Error
4400 Operator Access
4401 Operator Access
4402 Operator Access
4403 Operator Access
4404 Operator Access
4405 Operator Access
4406 Operator Access
4407 Operator Access
4408 Operator Access
4409 No mail generated
440A No mail generated
440B No mail generated
440C No mail generated
440D No mail generated
440E No mail generated
440F No mail generated
4410 No mail generated
4411 No mail generated
Tandberg Data M-Series Remote Management Card User's Guide
Description
Command failed due to reservation conflict
SCSI bus reset received
SCSI bus device reset message received
SCSI abort message received
SCSI parity error received
SCSI initiator detected error received
Time was set via serial port
Time set via synchronization command
Synchronize clock command issued
Library is rebooting
Library entering boot mode
Library has just started
Timeout waiting for remote ACK
Timeout waiting for remote response
Remote machine sent timeout message
Robot paused for operator safety (robotics accessible by operator)
Door 1 open (left door)
Door 2 open (right door)
Door 3 open
Door 4 open
Door 1 closed (left door)
Door 2 closed (right door)
Door 3 closed
Door 4 closed
Magazine 1 has been removed (left magazine)
Magazine 2 has been removed (right magazine)
Magazine 3 has been removed (left magazine)
Magazine 4 has been removed (right magazine)
Magazine 5 has been removed (left magazine)
Magazine 6 has been removed (right magazine)
Magazine 7 has been removed (left magazine)
Magazine 8 has been removed (right magazine)
Magazine 9 has been removed (left magazine)
55