Tandberg Data MSERIES RMC USER User Manual page 68

E-mail Message Error
FSC Code Type
2413 No mail generated
2415 No mail generated
2418 Soft Error
2629 Hardware Failure
2A00 Soft Error
4000 Soft Error
4001 Soft Error
4002 Soft Error
4003 Soft Error
4004 Soft Error
4005 Soft Error
4006 Soft Error
4007 Soft Error
4008 Soft Error
4009 Soft Error
400A Soft Error
400B Soft Error
400C Soft Error
400D Soft Error
400E Soft Error
400F No mail generated
4010 No mail generated
4011 Soft Error
4012 Soft Error
4013 Soft Error
4014 Soft Error
4015 Soft Error
4016 Soft Error
4017 Operator Access
4018 Operator Access
4019 Configuration Change
401A Operator Access
54 Tandberg Data M-Series Remote Management Card User's Guide
Description
Source slot not present. Magazine or drive removed.
Move medium attempted to drive that is being autocleaned
Requested action cannot be performed because robot is busy or in
use
A hand jam has been recovered
Shuttle queue is full
SCSI command received for invalid LUN
An ASC/ASCQ was used without updating error log logging
Illegal SCSI command received
Command received, but library is busy
Deferred error is pending
Unit attention–due to reset
Unit attention–due to mode parameters changed
Unit attention–due to medium changed
SCSI command had invalid field in CDB
SCSI command had parameter list length error
SCSI command had invalid field in parameter list
SCSI command had invalid parameter value
SCSI command failed due to servo problem
No sense available
Cleaner cartridge fitted
Move medium destination full
Move medium source empty
Parameters not saved. Undefined.
Illegal element number
Cannot complete command while cartridge is in hand
Power-on configuration not yet finished
Library will be ready soon, check back later
Not ready–unknown reason
Door is open
Import/export is open
Operator panel is in menu mode
Import/export has been accessed