Activating New Software Image - Tandberg Data MSERIES RMC USER User Manual

Remote management card
Table of Contents

Advertisement

Chapter 1 RMC Server Management
Utilities
Activating New
1
Software Image
14
Tandberg Data M-Series Remote Management Card User's Guide
Press
to place the new software image in a temporary
3
Upload
area of the system. A
been uploaded.
Press
to return to the
4
OK
If the library is rebooted before the uploaded
Note:
software image is activated, the image file is erased.
The upload process must be performed again.
The RMC system will use the new software image after completing
the
Activate the New Software Image
more information, see
A progress bar appears on the screen when performing a
Note:
software upload indicating when the process is
complete.
To move the uploaded software image from the temporary area,
replace the current software image, and activate the new software
image:
Access the
1
Utilities
Under
2
Activate New Software Image
bar indicates when the software has been activated.
The activation process takes several minutes. Do
Caution:
not interrupt the process. Doing so may result in
library failure and damage to the RMC.
Press
to return to the
3
OK
After completion of the
system uses the new software image the next time the RMC system
is rebooted. For more information, see
Library.
page indicates the software has
Results
page.
Utilities
and rebooting the RMC. For
Rebooting the RMC and
page. For more information, see Utilities.
, press
page.
Utilities
Activate New Software Image
Rebooting the RMC and
Library.
. A progress
Activate
, the RMC

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MSERIES RMC USER and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

M-series

Table of Contents