Accessing Community Management - Tandberg Data MSERIES RMC USER User Manual

Chapter 2 ALERT SNMP
ALERT SNMP Community Management
Accessing
Community
2
Management
Figure 9 Community
Management
20 Tandberg Data M-Series Remote Management Card User's Guide
• For SNMP get operations
• With read-write privileges for SNMP set operations
The following information is for setting up a community for SNMP
trap operations:
Community Name = createname
•
IP Address = xxx.xx.x.x
•
Subnet Mask = 255.255.255.0
•
• Access = read-only
An IP address or subnet mask set to
Note:
blank, indicates that IP-address-based access control is
disabled.
To access the
Community Management
under
ALERT SNMP
management frame displays the
shown in figure 9.
page, in the navigation frame
, press
Community Management.
Community Management
or left
0.0.0.0,
The
page as