Intel SRMK2 - Server Platform - 0 MB RAM Technical Specifications page 88

Beeps Error message
Display Memory
8
Read/Write Error
9 ROM Checksum Error
CMOS Shutdown
10 Register Read/Write
Error
Cache Memory Bad –
11
Do Not Enable Cache
Error Message
8042 Gate-A20 Error
Address Line Short!
C: Drive Error
C: Drive Failure
Cache Memory Bad, Do Not
Enable Cache!
CH-2 Timer Error
CMOS Battery State Low
CMOS Checksum Failure
CMOS System Options Not Set
CMOS Display Type Mismatch
CMOS Memory Size Mismatch
CMOS Time and Date Not Set
D: Drive Error
D: Drive failure
Diskette Boot Failure
Display Switch Not Proper
DMA Error
DMA 1 Error
DMA 2 Error
FDD Controller Failure
Intel ® SRMK2 Internet Server Technical Product Specification
The system video adapter is either missing or its memory is
faulty. This is not a fatal error.
The ROM checksum value does not match the value encoded
in AMIBIOS.
The shutdown register for CMOS RAM has failed.
The cache memory test failed. Cache memory is disabled. Do
not press <Ctrl> <Alt> <Shift> <+> to enable cache memory.
Table 62: BIOS Error Messages
Description
Gate A20 on the keyboard controller (8042) is not working.
Replace the 8042.
Error in the address decoding circuitry.
No response from drive C:. Run the AMIDiag Hard Disk Utility.
Check the C: hard disk type in Standard Setup.
No response from hard disk drive C:. Replace the drive.
Cache memory is defective. Run AMIDiag.
An AT system has two timers. There is an error in timer 2.
CMOS RAM is powered by a battery. The battery power is low.
Replace the battery.
CMOS RAM checksum is different than the previous value. Run
WINBIOS Setup.
The values stored in CMOS RAM have been destroyed. Run
WINBIOS Setup.
The video type in CMOS RAM does not match the type detected.
Run WINBIOS Setup.
The amount of memory found by AMIBIOS is different than the
amount in CMOS RAM. Run WINBIOS Setup.
Run Standard Setup to set the date and time.
No response from drive D:. Run the AMIDiag Hard Disk Utility.
Check the hard disk type in Standard Setup.
No response from hard disk drive D:. Replace the drive.
The boot diskette in drive A: cannot be used to boot the system.
Use another boot diskette and follow the screen instructions.
Some systems require a video switch be set to either color or
monochrome. Turn the system off, set the switch properly, then
power on.
Error in the DMA controller.
Error in the first DMA channel.
Error in the second DMA channel.
AMIBIOS cannot communicate with the floppy disk drive
controller. Check all appropriate connections after the system is
powered down.
Description
88