Installing Memory - Intel SE7501BR2 Installation And Integration Manual

Installing Memory

The server board supports only DDR266-
compliant DIMMs. The minimum supported
memory configuration is 256 MB, using two 128-
MB DIMMs. The maximum configurable memory
size is 8 GB using four 2-GB DIMMs.
Memory must be installed in pairs and must be
populated per bank starting with DIMM 1A and
1B (contiguous sockets). Although the
SE7501BR2 server board architecture allows the
user to mix various sizes of DIMMs between
banks, DIMMs must be identical within each
bank.
✏
NOTE
Use memory that has been tested for compatibility with the server board. For a list
of tested memory, see:
http://support.intel.com/support/motherboards/server/se7501br2/tested_mem.htm
If the server board is not already installed in the c
remove the server board from its packaging and place it
on a clean ESD-protected work surface.
1. Open both DIMM socket levers.
2. Insert DIMM, making sure the connector edge of the
DIMM aligns correctly with the slot.
3. Check that the socket levers are securely latched.
DIMMs must be populated in identical pairs.
Intel Server Board SE7501BR2 Installation and Integration Guide
hassis,
DIMM 1A
DIMM 1B
DIMM 2A
DIMM 2B
OM14665
11