Diagnostics - Cisco QuickVPN - PC Administration Manual

Administration

Diagnostics

Diagnostics
NOTE
STEP 1
STEP 2
Cisco SA 500 Series Security Appliances Administration Guide
You can use the Diagnostics page to assess configuration of the security
appliance and to monitor the overall network health.
These features require an active WAN connection.
Click Administration on the menu bar, and then click Diagnostics in the navigation
tree.
The Diagnostics page appears.
Perform the following tasks, as needed:
• Ping or Trace an IP Address: You can use these tools to test your network.
- Ping through VPN tunnel: Check the box to enable pinging through the
VPN tunnel. Otherwise, uncheck the box.
- To test connectivity between the security appliance and a connected
device on the network, enter the IP Address of the device and then click
Ping. The results appear in the Command Output page. Click Back to
return to the Diagnostics page.
- To view the route between the security appliance and a destination, enter
the IP Address of the destination, and then click Traceroute. The results
appear in the Command Output page. The report includes up to 30
"hops" (intermediate routers) between this security appliance and the
destination. Click Back to return to the Diagnostics page.
• DNS Lookup: To retrieve the IP address of any server on the Internet, type
the Internet Name in the text box and then click Lookup. If the host or
domain entry exists, you will see a response with the IP address. A message
stating "Unknown Host" indicates that the specified Internet Name does not
exist.
• Router Options: Choose from the following options:
- To view an IPv4 routing table or an IPv6 routing table, click the Display
button. The results appear in the Command Output page. Click Back to
return to the Diagnostics page.
9
204