Hardware Installation - Cisco QuickVPN - PC Administration Manual

Getting Started
Installation
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco SA 500 Series Security Appliances Administration Guide
Remove the four screws from each side of the security appliance.
Place one of the supplied spacers on the side of the security appliance so that the
four holes align to the screw holes. Place a rack mount bracket next to the spacer
and reinstall the screws.
If the screws are not long enough to reattach the bracket with the spacer,
NOTE
attach the bracket directly to the case without the spacer.
Install the security appliance into a standard rack as shown.

Hardware Installation

Follow these steps to connect the equipment:
Connect the security appliance to power.
If you are installing the SA 520W, screw each antenna onto a threaded connector
on the back panel. Orient each antenna to point upward.
For DSL, a cable modem, or other WAN connectivity devices, connect an Ethernet
network cable from the device to the WAN port on the back panel. Cisco strongly
recommends using Cat5E or better cable.
1
16