Table of Contents
Advertisement
DRAFT - 6/25/2010
Administration > Self Diagnostics
Diagnostics Trigger:
Choose whether you want to enable the diagnostics trigger.
VoD Monitor Trigger:
Choose whether you want the MoCA network performance to be recorded in the router
persistence log along with a TR-069 parameter for troubleshooting analysis when
necessary.
Diagnostics Settings
Schedule option:
Choose Enable if you want self-diagnostics to occur periodically, or
choose Disable to perform the self-diagnostics immediately, followed by the correction
procedure if enabled.
Diagnosis interval:
Choose how often the diagnostics tests should occur. The minimum
interval is one day.
Start time:
Enter the time that the diagnostics tests should start here, in 24-hour format.
WAN IP Polling Interval:
Enter the time interval that should pass before the next WAN IP
check, in seconds.The default value is 1 hour (3600 seconds).
Bandwidth Polling Interval:
Enter the time interval that should pass before the next
bandwidth polling test.
Enable Correction:
Choose Enable if the router should attempt to recover from any
Administration > Self Diagnosis
errors that it encounters, or choose Disable if you router should only log the error without
attempting to recover.
WAN DNS Domain:
Type the domain that is used to test DNS.
Correction Settings
Enable Factory Reset:
Choose whether or not to allow self diagnostics to reset the router
to the factory default. Choosing Enable will delete the user's configuration.
Factory Reset Trigger:
Errors that are detected by self diagnistics may trigger the router
to reboot. Specify how many reboots can take place before the router resets itself.
Correction Start Time:
Self diagnostics corrections do not take place immediately after
the error is detected. Specify when a self diagnostics correct should take place.
Diagnostics Threshold
Memory Threshold:
Specify the memory utilization that can be reached before corrective
action is taken.
WAN BW Threshold:
Specify the bandwidth utilization that can be reached before
corrective action is taken.
MoCA Rate Threshold:
Specify the MoCA rate utilization that can be reached before
corrective action is taken.
Diagnostics Cases
TBHR:
This test ensures that there are sufficient internal resources for the router to
operate optimally. The CPU and memory utilization snapshot should be taken during the
self-diagnostics operation or using a polling interval (BANDWIDTH_POLLING _INTERVAL).
TWANIP:
This test ensures that the router has a WAN IP assigned.
TLANMOCA:
This test only applies if the MoCA interface is enabled and active. It ensures
that the transmission rate for both Tx and Rx should be greater than 180Mbps.
32
Advertisement
Table of Contents
