Cisco QuickVPN - PC Administration Manual page 158

Configuring VPN
Configuring an IPSec VPN Tunnel for Remote Access with a VPN Client
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco SA 500 Series Security Appliances Administration Guide
Click VPN on the menu bar, and then click IPSec > VPN Wizard in the navigation
tree.
—OR—From the Getting Started (Advanced) page, under IPsec VPN Remote
Access, click VPN Wizard.
The VPN Wizard page appears.
In the About VPN Wizard area, choose Remote Access to allow the security
appliance to be accessed by remote PCs that are running VPN client software.
In the Connection Name and Remote IP Type area, enter the following information:
• What is the new connection name?: Enter a name for the connection. The
name is used for management and identification purposes.
• What is the pre-shared Key?: Enter the desired value, which the peer
device must provide to establish a connection. The length of the pre-shared
key is between 8 characters and 49 characters and must be entered exactly
the same here and on the remote client.
Do not use the double-quote character (") in the pre-shared key.
NOTE
• Local WAN Interface: If you have configured two WANs, choose the
interface that you want to use for this VPN tunnel. If you have only one WAN
configured, choose Dedicated WAN.
In the Remote & Local WAN Addresses area, enter the following information about
the remote server and the local server:
• Remote Gateway Type: Choose Fully Qualified Domain Name (FQDN),
and then enter a name Remote WAN's IP Address or Internet Name field to
identify the VPN client to the gateway.
• Local Gateway Type: This field can be left blank if you are not using a
different FQDN or IP address than the one specified in the WAN port's
configuration. Choose IP Address if you want to enter an IP address, or
choose Fully Qualified Domain Name (FQDN) if you want to enter a domain
name, such as vpn.company.com. Then enter that address or name in the
Local WAN's IP Address or Internet Name field.
Click Apply to save your settings, or click Reset to revert to the saved settings.
8
158