Assigning Vlans To Lan Ports - Cisco QuickVPN - PC Administration Manual

Networking
VLAN Configuration
NOTE
STEP 1
STEP 2
STEP 3
Cisco SA 500 Series Security Appliances Administration Guide
Next steps:
• Assign the VLANs to LAN ports. For more information, see
VLANs to LAN Ports, page
• Set up VLAN subnets. For more information, see
page 81.

Assigning VLANs to LAN Ports

To assign a VLAN to a LAN port, choose the mode and assign VLAN membership.
Click Networking on the menu bar, and then click LAN > Port VLAN in the
navigation tree.
The Port VLANs page appears. The existing port VLAN settings appear in the Port
VLANs table.
To update the settings for a port, click the Edit button.
In the VLAN Configuration area, enter the following information:
• Mode: Choose one of the following options:
- Access: The access port is a member of a single VLAN. All data going
into and out of the access port is untagged. By default, all VLAN ports are
in access mode. Access mode is recommended if the port is connected
to a single end-user device which is VLAN unaware.
If you choose this option, also enter a VLAN ID for the port, in the PVID
field.
- General: The port is a member of a specified set of VLANs. The port
sends and receives both tagged and untagged data. Untagged data
coming into the port is assigned the specified PVID. Data that is sent out
of the port from the same PVID is untagged. All other data is tagged.
General mode is recommended if the port is connected to an unmanaged
switch with a mix of VLAN-aware and VLAN-unaware devices.
If you choose this option, also enter a PVID number for the port, and
configure the VLAN Membership in the lower half of the page.
- Trunk: The port is a member of a specified set of VLANs. All data going
into and out of the port is tagged. Untagged data coming into the port is
not forwarded, except for the default VLAN with PVID=1, which is
80.
Multiple VLAN Subnets,
3
Assigning
80