Cisco QuickVPN - PC Administration Manual page 69

Networking
Configuring the Optional WAN
STEP 1
STEP 2
STEP 3
Cisco SA 500 Series Security Appliances Administration Guide
Click Networking on the menu bar, and then click Optional Port > Protocol
Bindings in the navigation tree.
—OR—From the Getting Started (Advanced) page, under Secondary WAN Port,
click Configure Protocol Bindings (Optional - if WAN Mode set to Load
Balancing).
The Protocol Bindings page appears. Any existing protocol bindings appear in the
List of Available Protocol Bindings table.
Click Add.
Other options: Click Edit to edit an entry. To enable a protocol binding, click
NOTE
Enable. To disable a protocol binding, click Disable. To delete an entry, check
the box, and then click Delete. To select all entries in the table, check the box
at the left side of the heading row.
After you click Add or Edit, the Protocol Bindings Configuration page appears.
Enter the following information:
• Service: Choose a service from the list.
The security appliance is configured with a list of standard services.
NOTE
For information about adding your own custom services to the list, see
Creating Custom Services, page
• Local Gateway: Choose the interface that you want to use: Dedicated
WAN or Configured WAN.
• Source Network: To identify the source network, choose Any, Single
Address, or Address Range. If you choose Single Address, enter the
address in the Start Address field. If you choose Address Range, enter the
Start Address and the End Address to specify the range.
• Destination Network: To identify the destination network, choose Any,
Single Address, or Address Range. If you choose Single Address, enter
the address in the Start Address field. If you choose Address Range, enter
the Start Address and the End Address to specify the range.
122.
3
69