Cisco QuickVPN - PC Administration Manual page 156

Configuring VPN
Configuring a Site-to-Site VPN Tunnel
STEP 5
STEP 6
NOTE
Cisco SA 500 Series Security Appliances Administration Guide
In the Secure Connection Remote Accessibility area, enter the following
information about the LAN at the remote site:
• Remote LAN IP Address: Enter the IP address of the remote LAN.
For the example illustrated in
address of 10.20.20.0.
• Remote LAN Subnet Mask: Enter the associated subnet mask for the above
entered subnet IP Address.
For the example illustrated in
mask of 255.0.0.0.
The IP address range used on the remote LAN must be different from
NOTE
the IP address range used on the local LAN.
Click Apply to save your settings, or click Reset to revert to the saved settings.
The settings are not saved on the Wizard page. The Wizard creates a VPN
NOTE
policy and an IKE policy based on your entries.
Next steps:
• If you are using the Getting Started (Advanced) page, click Getting Started
on the menu bar and then click Advanced in the navigation tree to return to
the list of configuration tasks for Site-to-Site VPN.
• To review or update the configured VPN policy click IPSec > VPN Policies
in the navigation tree. For more information, see
VPN Policies, page
• To review or update the configured IKE policy, click IPSec > IKE Policies in
the navigation tree. For more information, see
for IPSec VPN, page
• To configure IPSec passthrough, click IPSec > Passthrough. For more
information, see
Figure 8, the remote site, Site B, has a LAN IP
Figure 8, the remote site, Site B, has a subnet
166.
162.
Configuring IPSec Passthrough, page
Configuring the IPSec
Configuring the IKE Policies
171.
8
156