Step 2: Configuring The Access Points - Cisco QuickVPN - PC Administration Manual

Wireless Configuration for the SA 520W
Configuring an Access Point
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
Cisco SA 500 Series Security Appliances Administration Guide
At the top of the MAC Filtering page, set the ACL Policy Status. From the list,
choose one of the following options:
• Open: MAC filtering is not enabled. Any device can use this access point.
• Allow: All of the devices in the MAC Address table are allowed to use this
access point. All other devices are denied access.
• Deny: All of the devices in the MAC Address table are prevented from using
this access point. All other devices are allowed access.
Click Apply to save your settings, or click Reset to revert to the saved settings.

Step 2: Configuring the Access Points

Use the Access Point page to configure up to four access points to allow access
to your wireless network. For each access point, assign a profile, specify a
Service Set Identifier (SSID) or network name, set the maximum number of clients,
and, optionally, specify a schedule.
Click Wireless on the menu bar, and then click Access Point in the navigation tree.
The Access Points page appears. Existing access points are listed in the List of
Available Access Points table.
In the first row of the table, click the button in the Edit column to configure the
default access point.
Other options: Click Add to add an entry. To view the status, click the button
NOTE
in the Status column. To enable an access point, check the box and then click
Enable. To disable an access point, check the box and then click Disable. To
delete an access point, check the box and then click Delete. To select all
access points, check the box in the first column of the table heading.
After you click Add or Edit, the Access Point Configuration page appears.
Enter the following information:
• Profile Name: Choose a profile, which determines the security and optional
advanced settings for this access point. For more information, see
Configuring the Wireless Profiles, page 110.
4
Step 1:
116