Cdp - Cisco QuickVPN - PC Administration Manual

Network Management

CDP

STEP 1
STEP 2
STEP 3
CDP
NOTE
Cisco SA 500 Series Security Appliances Administration Guide
Click Network Management on the menu bar, and then click RMON in the
navigation tree.
The RMON page appears.
Enter the following information:
• Enable Remote Management?: By default, Remote management is
disabled. To enable WAN access to the configuration GUI check the box.
• Access Type: Choose the level of permission for remote management:
- Everyone: If this option is selected, be sure to change the default
password.
- IP Address Range: If this option is selected, enter the following:
- Only this PC: If this option is selected, set the following:
• From: the starting IP address for the allowed range
• To: the ending IP address for the allowed range
• IP Address: IP Address of the PC given remote management permissions
• Port Number: Displays the port number used for remote connection.
Click Apply to save your settings, or click Reset to revert to the saved settings.
Cisco Discovery Protocol (CDP) is a device discovery protocol that runs on all
Cisco manufactured equipment. Each CDP enabled device sends periodic
messages to a multicast address and also listens to the periodic messages sent
by others in order to learn about neighboring devices and determine the status of
these devices. This page provides the configuration options to control CDP.
Enabling CDP is not recommended on the Dedicated WAN port and the Optional
ports because they are connected to insecure networks.
10
216