Monitoring Mpls Status And Configuration - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x BGP and MPLS Configuration Guide

Monitoring MPLS Status and Configuration

Purpose
Action
Meaning
344
Display status and configuration information about MPLS.
To display information about MPLS Status and configuration:
host1#show mpls
MPLS administratively enabled
Current state is Config incomplete
LSR ID is 10.2.2.2
Re-optimization timer is 3600
Label range 3000 ~ 4000
retry forever at interval 30 during LSP setup if there is route
retry forever at interval 30 during LSP setup if there is no route
Loop Detect enabled
Additional detail is shown when LDP is enabled:
LDP
LSR ID is 80.0.0.2
FEC Deaggregation is off
Egress label: implicit-null
Label distribution control mode: ordered control
LDP session retry 0 times at interval 10
LDP session hold time: 180
LDP session keepalive interval: 20
LDP targeted-hello hold time: 45
LDP targeted-hello interval: 15
Topology Driven LSP enabled
LSPs used for IP forwarding
for host addresses only
Additional detail is shown when RSVP-TE is enabled:
RSVP is enabled
LSRID 10.1.1.1
Re-optimization timer is 3600
Tunnel retry forever at interval 5 if route is available
Tunnel retry forever at interval 5 if no route is available
Refresh reduction is OFF
Message bundling is OFF
Egress label is non-null
Hellos are on with an interval of 10000 and miss limit of 4
Graceful restart is ON
Restart time 60000 milliseconds
Recovery time 120000 milliseconds
Additional detail shown when RSVP-TE graceful restart helper mode is enabled:
RSVP is enabled
...
Graceful restart is ON (helper mode)
Table 72 on page 345 lists the show mpls command output fields.
Copyright © 2010, Juniper Networks, Inc.