Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 386

JunosE 11.3.x BGP and MPLS Configuration Guide
350
queue 0: traffic class best-effort, bound to atm-vc ATM2/0.10
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
MPLS minor interface lsp-02020202-1-4 (receive)
Stacked on MPLS major ATM2/0.10
Operational state is up
Statistics not enabled for this interface
The following excerpt shows the output for MPLS interface atm 5/1.1 when RSVP-TE
is enabled and RSVP-TE authentication is enabled:
host1:pe2#show mpls interface atm 5/1.1
Interface ATM5/1.1 Up
RSVP enabled with profile default
Authentication: enabled
Authentication Key: <a password has been configured>
LDP not configured
IP interfaces on this MPLS interface:
192.168.100.21/30
MPLS Statistics:
Rcvd: 0 failed lbl lookup, 0 octets, 0 hcOctets
0 pkts, 0 hcPkts, 0 errors, 0 discards
Sent: 0 octets, 0 hcOctets, 0 pkts
0 hcPkts, 0 errors, 0 discards
...
To display information about MPLS interface atm 2/0.60:
host1:pe2#show mpls interface atm 2/0.60
Interface atm2/0.60 Up
RSVP not configured
LDP enabled with profile default
IP interfaces on this MPLS interface:
60.60.60.1/16 Session to 4.4.4.4 is operational (active)
Session statistics:
12 label alloc, 12 label learned,
12 accum label alloc, 12 accum label learned,
last restart time = 00:04:44
Rcvd: 0 notf, 29 msg, 12 mapping, 0 request
0 abort, 0 release, 0 withdraw, 1 addr
0 addr withdraw, 29 msgId
0 bad mapping, 0 bad request, 0 bad abort, 0 bad release
0 bad withdraw, 0 bad addr, 0 bad addr withdraw
0 unknown msg type err
last info err code = 0x00000000, 0 loop detected
Sent: 0 notf, 29 msg, 12 mapping, 0 request
0 abort, 0 release, 0 withdraw, 1 addr
0 addr withdraw, 29 msgId
Adjacency statistics:
58 hello recv, 57 hello sent, 0 bad hello recv
adj setup time = 00:04:44
last hello recv time = 00:00:05, last hello sent time = 00:00:05
MPLS Statistics:
Rcvd: 0 failed lbl lookup, 0 octets, 0 hcOctets
0 pkts, 0 hcPkts, 0 errors, 0 discards
Sent: 0 octets, 0 hcOctets, 0 pkts
Copyright © 2010, Juniper Networks, Inc.