JunosE 11.3.x BGP and MPLS Configuration Guide
OutDiscards:
1 interface(s) found
Related
Documentation
Configuring HDLC Layer 2 Services
544
0
atm cell-packing
atm mcpt-timers
atm pvc
interface atm
interface loopback
ip address
mpls-relay
show atm mcpt-timers
show atm subinterface
The following commands configure an HDLC layer 2 circuit over MPLS between an E Series
router and a remote PE device.
To configure an HDLC layer 2 circuit over MPLS:
Configure a serial or POS interface on the ingress router.
1.
host1(config)#interface serial 3/1:2/1
or
host1(config)#interface pos 4/0
Use one of the following methods to create the HDLC layer 2 circuit over MPLS:
2.
Use the mpls-relay or route interface command without the relay-format ppp
keywords. This command causes the router to signal VC-type HDLC on the LDP
session and use HDLC encapsulation. Use this command syntax if the traffic carried
on the serial or POS interface is any kind of standard HDLC (including PPP) or Cisco
HDLC.
host1(config-if)#mpls-relay 2.2.2.1 1
or
host1(config-if)#route interface tunnel mpls:tunnel-to-pe2 1
Use the mpls-relay or route interface command with the relay-format ppp
keywords. This command causes the router to signal VC-type PPP on the LDP
session and use PPP encapsulation instead of the default VC-type HDLC signaling
and HDLC encapsulation. Use this command syntax if the traffic carried on the serial
or POS interface contains actual PPP packets.
host1(config-if)#mpls-relay 2.2.2.1 1 relay-format ppp
or
Copyright © 2010, Juniper Networks, Inc.