Configuring Vpws; Configuring Vpws On A Pe Router - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers bgp and mpls configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (786 pages)
Table of Contents
Advertisement
CHAPTER 15
Configuring VPWS
Configuring VPWS on a PE Router
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure virtual private wire service (VPWS) L2VPNs on
the router, and contains the following sections:
Configuring VPWS on a PE Router on page 659
Configuring an VPWS Instance on page 660
Configuring BGP Multihoming for VPWS on page 661
Types of Interfaces to Configure in the VPWS Instance on page 662
Configuring Customer-Facing Interfaces in the VPWS Instance on page 662
Local Cross-Connects for VPWS Overview on page 663
Configuring a Local Cross-Connect for VPWS on page 663
BGP Loopback Interface and Router ID Overview on page 664
Configuring the Loopback Interface and Router ID for BGP for VPWS on page 664
BGP Signaling for VPWS Overview on page 664
Configuring BGP Signaling for VPWS on page 665
MPLS LSPs for VPWS Overview on page 666
Configuring MPLS LSPs for VPWS on page 666
Example: Configuring VPWS on Local and Remote Routers on page 667
To configure a PE router to provide VPWS:
Configure an VPWS instance.
1.
See "Configuring BGP Multihoming for VPWS" on page 661 and (optional) "Configuring
an VPWS Instance" on page 660
Configure the customer-facing interfaces in the VPWS instance.
2.
See "Configuring Customer-Facing Interfaces in the VPWS Instance" on page 662
(Optional) Configure local cross-connects.
3.
See "Configuring a Local Cross-Connect for VPWS" on page 663
Configure the loopback interface and router ID for BGP.
4.
659
Advertisement
Table of Contents
Troubleshooting
