Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 679

Copyright © 2010, Juniper Networks, Inc.
Table 131: show vpls connections Output Fields (continued)
Field Name
Route Distinguisher
SiteName
Transport Virtual Rtr
Multihomed priority
SiteId
SiteRange
VPLS Route Targets
Flood Next Hop
Interface
Port
Status
Connections status code
Site
State
Remote PE
In-label
Out-label
Field Description
Unique route distinguisher configured for the VPLS instance
Site name configured for the VPLS instance
Identifier for the PE router that acts as the transport virtual router
for the VPLS instance
Priority of the VPLS instance to serve as the backup PE router for
the CE device in the event of a network failure in the multihomed
configuration; indicates also that the site is multihomed
Numerical site identifier configured for the VPLS instance
Maximum number of sites that can participate in the VPLS domain
associated with the VPLS instance
Extended community identifiers, also known as route targets, for
each VPLS instance configured on the router
Index number of the MPLS next hop to which the router floods
packets with unknown destination addresses. For more information
about displaying MPLS next hops and any available next-hop
statistics, see "Monitoring MPLS Next Hops" on page 356.
Type and specifier of the network interfaces and VPLS virtual core
interface associated with the VPLS instance; vpls vplsName in this
field identifies the VPLS virtual core interface
Port number of the module on which the network interface or VPLS
virtual core interface resides
Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
Possible status codes for the VPLS connection that appear in the
State field
Remote site identifier
Status of the connection with the remote VPLS instance; possible
values for this field appear in the Connections status code legend
in the command display
IP address of the remote VPLS edge (VE) router, which is analogous
to the remote provider edge (PE) router in a BGP/MPLS VPN
configuration
Incoming MPLS label from the remote site
Outgoing MPLS label used to reach the remote site
Chapter 13: Monitoring VPLS
643