Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 388

JunosE 11.3.x BGP and MPLS Configuration Guide
352
0 failed label lookups
Sent:
0 packets
0 bytes
0 errors
0 discards
RSVP
Enabled with profile default
Authentication is disabled
Authentication key: <none>
MPLS minor interface pe1-to-pe2 (transmit)
Stacked on MPLS major ATM2/0.10
Operational state is up
MPLS minor interface UID is 0x1a000001
Lower MPLS major interface UID is 0x19000001
Sent:
0 packets
0 bytes
queue 0: traffic class best-effort, bound to atm-vc ATM2/0.10
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
MPLS minor interface lsp-02020202-1-4 (receive)
Stacked on MPLS major ATM2/0.10
Operational state is up
MPLS minor interface UID is 0x1a000004
Lower MPLS major interface UID is 0x19000001
Statistics not enabled for this interface
The following excerpt shows detailed RSVP-TE information for the MPLS interface:
host1:vr2#show mpls interface detail
MPLS major interface fastEthernet6/0
RSVP
Enabled with profile default
Authentication is disabled
Authentication key: <none>
Hellos are enabled
Hellos interval is 10000 milliseconds
Hellos miss limit is 4
Hello settings are not inherited
To display summary information about MPLS interfaces:
host1:pe1#show mpls interface brief
MPLS major interfaces
Admin Oper
Interface state state
--------- ------- -----
ATM2/0.10 enabled up
MPLS shim interfaces
Remote-PE
or
Interface LSP-name
--------- ---------
Virtual Load
Circuit Balancing Admin
ID Group state
------- --------- -----
Oper
state
-----
Copyright © 2010, Juniper Networks, Inc.