Monitoring Mpls - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

CHAPTER 5

Monitoring MPLS

Copyright © 2010, Juniper Networks, Inc.
This chapter describes the commands you can use to monitor and troubleshoot
Multiprotocol Label Switching (MPLS) on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor
and show commands is identical to output from other E Series routers, except
that the E120 and E320 router output also includes information about the
adapter identifier in the interface specifier (slot/adapter/port).
This chapter contains the following sections:
Setting the Baseline for MPLS Statistics on page 322
Clearing and Re-Creating Dynamic Interfaces from MPLS Major Interfaces on page 324
Clearing and Refreshing IPv4 Dynamic Routes in the Tunnel Routing Table on page 325
Clearing and Refreshing IPv6 Dynamic Routes in the Tunnel Routing Table on page 325
Tracing Paths Through the MPLS User Plane on page 325
Monitoring ATM VCs and VPI/VCI Ranges Used for MPLS on page 326
Monitoring Global Call Admission Control Configuration on page 327
Monitoring Interfaces Configured with Traffic Engineering Bandwidth
Accounting on page 327
Monitoring Virtual Router Configuration on page 328
Monitoring IP and IPv6 Tunnel Routing Tables on page 329
Monitoring LDP on page 330
Monitoring MPLS Label Bindings on page 332
Monitoring LDP Graceful Restart on page 333
Monitoring Interfaces That are Synchronizing with LDP on page 334
Monitoring LDP Interfaces on page 335
Monitoring LDP Neighbors on page 337
Monitoring LDP Profiles on page 340
Monitoring LDP Statistics on page 340
Monitoring LDP Targeted Hello Receive and Send Lists on page 343
321