JunosE 11.3.x BGP and MPLS Configuration Guide
Related
Documentation
Monitoring the VRF Routing Table
Purpose
Action
498
Table 96: show ip protocols Output Fields (continued)
Field Name
System Version
Update interval
Invalid after
hold down time
flushed interval
Filter applied to outgoing
route update
Filter applied to incoming
route update
Global route map
Distance
Interface
Redistributing
Routing for Networks
show ip protocols
Display the routing table of the specified VRF
To display the routing table of the VRF
host1#show ip route vrf vpn2
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
Prefix/Length
Type
--------------- -------
Field Description
RIP versions allowed for sending and receiving RIP updates. The
system version is currently set to RIP1, which sends RIP version 1 but
will receive version 1 or 2. If the version is set to RIP2, the system will
send and receive version 2 only. The default is configured for RIP1.
Current setting of the update timer (in seconds)
Current setting of the invalid timer (in seconds)
Current setting of the hold down timer (in seconds)
Current setting of the flush timer (in seconds)
Access list applied to outgoing RIP route updates
Access list applied to incoming RIP route updates
Route map that specifies all RIP interfaces on the router
Value added to RIP routes added to the IP routing table. The default
is 120.
Interface type on which RIP protocol is running
Protocol to which RIP is redistributing routes
Network for which RIP is currently injecting routes
Next Hop
Dist/Met
----------
--------
Intf
------------
Copyright © 2010, Juniper Networks, Inc.