Setting A Baseline For A Vpls Instance; Instance; Vpls Instance; Clearing Dynamic Mac Addresses From The Vpls Forwarding Table - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x BGP and MPLS Configuration Guide

Setting a Baseline for a VPLS Instance

Setting a Baseline for a Network Interface associated with a VPLS Instance
Setting a Baseline for the VPLS Virtual Core Interface associated with a VPLS Instance
Related
Documentation

Clearing Dynamic MAC Addresses from the VPLS Forwarding Table

618
reading and storing the statistics at the time the baseline is set and then subtracting this
baseline whenever baseline-relative statistics are retrieved.
Use the delta keyword with the show bridge commands display baselined statistics.
Tasks to set a baseline for VPLS statistics are:
Setting a Baseline for a VPLS Instance on page 618
Setting a Baseline for a Network Interface associated with a VPLS Instance on page 618
Setting a Baseline for the VPLS Virtual Core Interface associated with a VPLS
Instance on page 618
To set a statistics baseline for a VPLS instance:
Issue the baseline bridge command.
host1#baseline bridge vplsA
To set a statistics baseline for the VPLS network interface:
Issue the baseline bridge interface command.
host1#baseline bridge interface gigabitEthernet 4/1
To set a statistics baseline for the VPLS virtual core interface:
Issue the baseline bridge interface vpls command.
host1#baseline bridge interface vpls vplsA
baseline bridge
baseline bridge interface
baseline bridge interface vpls
You can use the following clear commands to remove all dynamic (learned) MAC address
entries or a specific dynamic MAC address entry from the forwarding table for a VPLS

instance.

Tasks to clear the VPLS forwarding table are:
Clearing All Dynamic MAC Addresses from the VPLS Forwarding Table on page 619

Clearing a Specific Dynamic MAC Addresses from the VPLS Forwarding

Table on page 619
Copyright © 2010, Juniper Networks, Inc.