Table 99: Show Mpls L2Transport Load-Balancing-Group Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x BGP and MPLS Configuration Guide
Meaning
506
Outgoing Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Interface fastEthernet 3/0.2
Incoming Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Outgoing Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
NOTE: For a simpler view, the show mpls l2transport interface command
displays only the currently active VLAN or S-VLAN subinterface. Because
load-balanced circuits are configured on subinterfaces on multiple ports,
only one of which is active at a given time, this command does not give a
complete picture of the configuration.
Table 99 on page 506 lists the show mpls l2transport load-balancing-group command
output fields.

Table 99: show mpls l2transport load-balancing-group Output Fields

Field Name
routed to/base LSP
load-balancing group
Martini group-id
state
vc-id
mtu
In label
Out label
pkts
hcPkts
octets
hcOctets
Field Description
Identifies address of the router at the other end of the tunnel and
the base tunnel that is selected to forward the traffic
Group number
Martini group ID number for the interface
State of the interface
VC ID number for the interface
Maximum transmission unit for the inter
Label sent to upstream neighbor for route; statistics below this field
are the aggregate statistics for traffic from the core
Label received from downstream neighbor for route; statistics below
this field are the aggregate statistics for traffic to the core
Number of packets sent across tunnel
Number of high-capacity (64-bit) packets sent across tunnel
Number of octets sent across tunnel
Number of high-capacity (64-bit) octets sent across tunnel
Copyright © 2010, Juniper Networks, Inc.