Configuring Ssm; Finding Feature Information; Prerequisites For Configuring Ssm - Cisco Catalyst 2960-XR Configuration Manuals

Configuring SSM

•
•
•
•
•
•
•
•
•

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.

Prerequisites for Configuring SSM

The following are the prerequisites for configuring source-specific multicast (SSM) and SSM mapping:
• Before you configure SSM mapping, you must perform the following tasks:
OL-29426-01
Finding Feature Information, page 77
Prerequisites for Configuring SSM, page 77
Restrictions for Configuring SSM, page 78
Information About SSM, page 79
How to Configure SSM, page 82
Monitoring SSM, page 89
Where to Go Next, page 89
Additional References, page 90
Feature History and Information for SSM, page 91
◦ Enable IP multicast routing. For information about this procedure, see
Multicast Routing
◦ Enable PIM sparse mode. For information about this procedure, see
page 45
Catalyst 2960-XR Switch IP Multicast Routing Configuration Guide, Cisco IOS Release 15.0(2)EX1
5
C H A P T E R
Configuring Basic IP
How to Configure PIM, on
77