Enabling / Disabling The Squawk Option; Programming The Scheduler - Visonic PowerMaster-10 G2 User Manual

MENUS AND FUNCTIONS
14
The display shows the currently selected option (indicated by a
Using the
telephones numbers according to the options provided in the tables below:
Event Group Option
alarms+alrt
alarm
alert
disable report
15
You can now, select other options, end this session – (see section A.1 and section A.2), or quit
programming (see section A.3).
B.13 Enabling / Disabling the Squawk Option
The PowerMaster system (and its wireless sirens) can be set to produce a short "Squawk" of audible feedback
to assist you when you use your keyfob to arm (1 beep) and disarm (2 beeps) the PowerMaster system
(operates in a similar manner to a car alarm).
♦ Here you can enable / disable the Squawk.
Carefully read the section titled "Additional Information" according to the indicated references
table at end of this section.
1.
SQUAWK
Squawk on
2.
or
Squawk OFF
3.
Squawk OFF
☺ Return to step 1
1
For detailed instructions on how to select User Settings – refer to sections A.1 and A.2.
2
a. The display shows the currently selected setting (indicated by a
b. You can now enable (ON) or disable (OFF) the Squawk option using the
3
The symbol now appears next to the new selected option.
4
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).
B.14 Programming the Scheduler
The PowerMaster system includes a PGM output that can be used to open and close an electrically-controlled
gate, or to control a preferred electrical device via keyfobs (refer to "Using keyfob transmitters" in Chapter 2) or
according to a programmable weekly time schedule.
♦ Here you can schedule the PGM output for up to 4 different ON/OFF time activations per any desired day or
days of the week. In addition, you can schedule a "Daily" schedule that applies to every day of the week. It is
recommended to complete the Scheduler table (placed at the end of this section) before programming the
Scheduler.
Carefully read the section titled "Additional Information" according to the indicated references
table at end of this section.
42
or buttons you can now select the events you wish to be reported to MMS
Events to be reported
Alarm and alert messages
Alarm messages
Alert messages
No message will be reported
Enter the [USER SETTINGS] menu, select the [
1
.
The display shows the currently selected setting.
Click the
setting, for example, "Squawk OFF" and press the
A "Happy Tune"
then returns to the User Settings menu, step 1.
Additional Information (section B.13)
symbol), for example, "
or button until the display reads the desired
☺ sounds. The display confirms the saved setting, and
symbol), for example, [
D-304829 PowerMaster-10/30 G2 User's Guide
disable report
".
1
etc – see
SQUAWK
] option and press
2
button to confirm.
3, 4
Squawk ON
or button.
1
etc – see
].